Page 1 of 1

02-10-2018 ST1300A Update.

PostPosted: 02 Oct 2018, 06:30
by alans1100
At the end of October our recently purchased 1300A will be going off road for a few weeks for a minor make over. Essentially have to strip the plastic off to do the wiring.

Over the last few months I have gathered the following:-

Quartet harness

DSC_1829.JPG (213.84 KiB) Viewed 2689 times

43721802565_82669baeb7_o.jpg (71.78 KiB) Viewed 2689 times

12 volt DC socket

12v-dc-socket_medium08V70MCS800-01_7a63.jpg (35.79 KiB) Viewed 2689 times

Migsel Mount

Not pictured is another screw in ball mount (same as one in image) so I can mount the phone mount as well.

main_pan-a.jpg (76.86 KiB) Viewed 2689 times

TomTom Rider 450 power cradle.

Will connect this to a switched circuit in the quartet harness.

DSC_1831.JPG (263.65 KiB) Viewed 2689 times

Re: 02-10-2018 ST1300A Update.

PostPosted: 31 Dec 2018, 05:12
by alans1100
With what looks like an end to Forum hosting in the next day or two I may as well finish this off by just adding a link to the post on Ozstoc. If by some chance the Forum is reactivated then this post as an ending off site. ... msg1246492

And the Migsel mount here ... msg1247941

Re: 02-10-2018 ST1300A Update.

PostPosted: 04 Jun 2019, 05:33
by alans1100
A few weeks ago I ordered some LED stop/tail globes ... 443-48h-r2

I have fitted these and they even look okay in the day.

OEM LH bulb and LED RH

20190407_164243.jpg (311.36 KiB) Viewed 1309 times

Both LED globes installed

20190407_164246.jpg (307.56 KiB) Viewed 1309 times

These ... h-black-r2 for the parking light which we don't actually use as such since we don't have a headlight switch but not installed yet.

Considering LED for the indicators but not sure if the indicator relay needs to be replaced as well.